This plugin estimates the TCP traffic performance degradation from coarse link utilization traces, such as those obtainable by SNMP.

Check that 2 (or more) PSUs are present and working in a Cisco switch. Usually a removed PSU won't be noticed since there is no…

simple bash script to check status of rhcs on member node. uses cman_tool, and clustat for information. script is extremely bare, but one day might…

Check cisco switch interface for reliability changes

Check cisco switch for half duplex ports

Check cisco switch for err-disabled ports

Check AP under a MSM 760 series controller and notify if some AP is not connected/sync.

For "Test run" type job it throws critical state while the job finishes successfully.

If i run "./check_snmp_int.pl -H 10.1.1.1 -C banana -n outside" I get back: Adaptive Security Appliance 'outside' interface:UP:1 UP: OK If i run "./check_snmp_int.pl -H…

the plugin is zero byte in size, what is built in?

Plugin generally works, but exit codes are not correct, so it will show Warning in all cases. To correct this, replace the code with: if…