Most Popular Listings

Check RAID, Drive, and Environmental sensors on an ARECA RAID controller via SNMP

Fetches/checks environment and health stats from HP Procurve switches (fans, power supplies, temps, etc)

This plugin will remotely check the network speed of your Linux/Solaris server using SNMP. Usage: check_interface.pl -H, --hostname=HOST name or IP address of host to…

This tutorial demonstrates how to configure Nagios on Ubuntu.

This is a basic plugin to locate all suitable disks on a system and then run checkdisk_ide_smart against each of them, returning a single result.

This white paper describes a software plug-in that can be used with the Nagios Core infrastructure monitoring framework to display the state of a wide…

This article shows you how to install, enable, and configure the SNMP service in Windows XP, Vista, and 2003.

This tutorial demonstrates how to setup a Nagios failover server.

checks for murmurd via dbus free for non-commercial use

check_multimedia_stream is Nagios plugin to monitoring mpeg's transport streams.

This article will show you how to use a SMS server to increase the reliability and dependability of receiving critical alerts and notifications in Nagios.

Monitor the status of Progress: Adminserver Nameserver Appserver

Via SNMP, checks the total and used memory on HP-UX servers and can create graphs.

This tutorial will show you how to install Nagios 3.2.3 in Fedora 14 from source.

This tutorial shows you how to monitor Dell server hardware in Nagios with SNMP.

This article will demonstrate how to setup a regional Nagios server.

This tutorial describes one approach of monitoring the patch compliance of network devices.

Use these custom event handlers to create and close helpdesk tickets in the GLPI helpdesk software.

A Nagios plugin to monitor apache via the mod_status module. This plugin assumes you have mod_status enabled and ExtendedStatus set to On.

This python plugin tests if your main internet or backup internet connection is active. Tested with Nagios Core 3.3.1 and Python 2.7

The Solaris agent has been tested on Solaris 10, both x86 and SPARC. Agent Installation Instructions can be found at: https://assets.nagios.com/downloads/nagiosxi/docs/Installing_The_XI_Solaris_Agent.pdf