Network Connections, Stats and Bandwidth

Modified Version 42, added a minum value section, needed for ipsec tunnels. Changed the bottom output sections, because it wasn't triggering the nagios event handler.…

Check the AWS Service Health Dashboard for service interruptions/incidents.

A simple plugin to check connected clients to an Aironet device. Usage: check_cisco_aironet_clients.pl -H -U -P [ -I ] [ -w -c ]

check cisco port-channel members status

Shell script to test upload average speed.

check_snmp_if is a Nagios plugin that checks interfaces via SNMP (IF-MIB).

Based on check_dot3.pl (which never seemed to work as written). I decided to use Net::SNMP::Interfaces::Details to get InErrors and OutErrors instead. It also requires the…

A small script to check when providers change under dynamic routing. Useful when you have frequent trouble with the upper tier or channels to well…

Check established connections using netstat.

This script will check the traffic and status of an interface, in just about the same way as check_iftraffic.pl does.

Checks for the existence of a wireless SSID without connecting to the wireless network. Only provides a binary up/down response by polling the wireless card…

Supports all Cisco standard interfaces: TenGigabitEthernet, GigabitEthernet, FastEthernet, Ethernet, Port-channel, Vlan. Also works on standard NIC adaptors. Checks input/output traffic, unicast pkts, multicast pkts, broadcast…