check_interfaces_wmi

Project Notes

This is to bypass the limitations of the 32-bit SNMP v2 counters used by Windows.

It produces valid perfdata for input(RX) & output(TX) and can provide either raw data outputs or percentage based.

This plugin has a prerequisite of the check_nt plugin being present and a suitable agent on the servers being monitored.

Options:
-h, --help show this help message and exit
-H HOST, --host=HOST Hostname/FQDN or IP address
-p PORT, --port=PORT Port that nc_net or nsclient++ is running on (1248)
-w WARNING, --warning=WARNING
Warning Threshold (percentage of interface speed
default to 70 see also -r/--raw)
-c CRITICAL, --critical=CRITICAL
Critical Threshold (percentage of interface speed
default to 90 see also -r/--raw)
-S, --special Include special interfaces Teredo IPv6 tunnel and
isatap
-D, --disconnected Include disconnected interfaces (interface speed = 0)
-P PREFIX, --prefix=PREFIX
Prefix to Be used Kilo/K, Mega/M, Giga/G, if none
specified bits/bytes will be used
-r, --raw Use raw values for Warning and Critical thresholds
(affected by prefix used i.e. -r -w 1000 -c 2000 -P
kilo will set Warning threshold to 1000 Kilobits/sec
and Critical threshold to 2000 Kilobits/sec)
-R, --rawperfdata Use raw values for Performance Data thresholds (Can be
used in combination with -r i.e. -r -R )